If you want to find out what circuit is causing the battery drain by use of a good multi meter that allows supporting about 10 amps for current loads
As I picture below
Take off the positive battery lead cable and connect like a #14 Gage wire from it to the + of battery post
Connect both leads of meter to each side of that wire.
Set meter to Amps
Allow good 15 minutes for all controllers to go into sleep mode.
Cut the wire and turn meter on in Amps mode.
Write down what the AMP reading is
One by One pull a fuse and see if the Amp reading goes down
If not pull next fuse, repeat until you find the circuit that is putting the load on battery
May have to do this for each fuse panel the vehicle has
View attachment 574998