Cadillac Owners Forum banner
Cancel

WP #5 Done - Change Clutch Disc and Pressure Plate.

610 Views 3 Replies 2 Participants Last post by  PISNUOFF, 
G
I finally got off my lazy butt and swapped out my LS7 disc and PP. My last one has been sticking to the floor and not pressing in at high rpms. After installation I drove around for a while and then pressed in the clutch at a light and rev'd it up and the pedal stuck to the floor. That must have been it self-adjusting and it has not done it since. It is currently working perfectly. We'll see how it is after BeaveRun on April 24th.
Reply
Save
Like
1 - 4 of 4 Posts
Twitch
Did you change anything, or just put in new LS7 parts?
Just wondering if this is something that'll come up again.
Reply
Save
Like
S
Sounds like a faulty slave cylinder.
Reply
Save
Like
G
Did NOT change the slave cylinder and the problem was fixed. Changing the pressure plate was the key to solving the functional issues. I'm sure I'll be wearing this one out also.
Reply
Save
Like
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cadillac Owners Forum
Cadillac Forums is the perfect place to go to talk about your favorite Caddys including the ATS, CTS, SRX and Escalade.
Full Forum Listing
Explore Our Forums
Informal Lounge, Introductions, General Discussion CTS First Generation Forum - 2003-2007 Seville and Eldorado Forum FWD DeVille 1985-2005, Fleetwood, and 60 Special 2004-2007 CTS-V General Discussion
Top