Cadillac Owners Forum banner
1 - 1 of 1 Posts

· Registered
14 Posts
Discussion Starter · #1 ·
I am replacing the wheel bearing / hub assembly on my 91 Deville. After taking the old one off, when I slide the new one on the splines it engages fine but does not seem to want to go all the way in. I could draw it on in with the bolts but it pushes on the axle (about 1/4 to 3/8 of an inch) and I am sure this just can't be right. Or is it? What am I doing wrong?
Thanks in advance for any help. Frustrated and stranded - for now...
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.