Cadillac Owners Forum banner
1 - 1 of 1 Posts

· Registered
2008 SRX-V8, 1991 Eldorado
Joined
·
1,544 Posts
I am surprised nobody answered this....

What you DO NOT WANT TO HAPPEN is for the axle to be drawn out of the transaxle. The correct procedure is outlined in the FSM (Factory Service Manual) but if you don't have one, You can torque the spindle nut to 150 lbs.ft, while rotating the hub assembly, then back the nut out and torque it again to 120 lbs.ft. This is to set the bearing in the hub assembly. I don't have my manual handy right now but I have used these numbers myself.

Hope this helps.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top