Cadillac Owners Forum banner
Cancel

Trim alignment

570 Views 4 Replies 3 Participants Last post by  Bee1, 
B
Was walking to my car today and notice the doors did not line with body. On closer inspection, it's the window trim popping up, probably a loose nut or screw holding the trim down.
Anyone have experience on how to access those screws or nuts?

Driver door and pass.

Sent from my SM-J700P using Tapatalk
See less See more
Reply
Save
Like
1 - 1 of 5 Posts
D
Automotive window part Line art Auto part Automotive exterior Diagram


Make sure the doors are not out of alignment. Look at the top and bottom of the doors.
To get to the screws for the Door Frame Reveal Molding, You need to take off the inner door trim panel and outside mirror.
# 1.
Front Door Frame Reveal Molding Screw (Qty: 9)
See less See more
Reply
Save
Like
  • Like
Reactions: 1
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cadillac Owners Forum
Cadillac Forums is the perfect place to go to talk about your favorite Caddys including the ATS, CTS, SRX and Escalade.
Full Forum Listing
Explore Our Forums
Informal Lounge, Introductions, General Discussion CTS First Generation Forum - 2003-2007 Seville and Eldorado Forum FWD DeVille 1985-2005, Fleetwood, and 60 Special 2004-2007 CTS-V General Discussion
Top