[modliving]

Does anyone have the torque values? I'm replacing the strut mounts this week to finally eliminate the clunking. TIA

 

[Tripwire]

this help?

 

[tta1456]

Link to a PDF of the factory service manual...

Here's the ATS 2016 Factory Service Manual for...

It's too large for this site to host it, so here's my public folder. Index of /ATS files The full service manual is in there, as well as individual sections for ease of use. Enjoy, hope someone can use it. Contents of folder: 2016 ATS Factory Ser..> 665M 2016 ATS Owner...

www.cadillacforums.com

FYI, at least a couple of the bolts in the rear suspension are torque to yield and are single use. Not 100% sure if there are any TTY bolts in the front suspension.

 

[Crisis]

Here is the Front

1. Front Suspension Strut (1) » Install
   
   Open In New TabZoom/Print
2. Partially lower the vehicle.
3. Front Suspension Strut Upper Mounting Nut (1) » Install, but do NOT tighten [3x]
   
   Open In New TabZoom/Print
4. Raise the vehicle.
5. Front Suspension Strut Bolt (2) » Install [2x]
   
   Open In New TabZoom/Print
6. Caution: Refer to Fastener Caution.
7. Front Suspension Strut Nut (1) » Install [2x]
   1. Tighten
   2. First Pass: 150 Nm (111 lb ft)
   3. Final Pass: (80–95 degrees)
8. Front Stabilizer Shaft Link (1) @ Strut Assembly » Install — Stabilizer Shaft Link Replacement
   
   Open In New TabZoom/Print
9. Install the front brake hose clip (1) on the front strut assembly bracket. Front Brake Hose Replacement
   
   Open In New TabZoom/Print
10. Install the front wheel speed sensor harness clip (3) in the front strut assembly bracket.
    
11. Install the electronic suspension wiring harness clip (2) in the front strut assembly bracket and connect the electronic suspension wiring connector (1).
12. Install the front tire and wheel assembly. Tire and Wheel Removal and Installation
13. Lower the vehicle completely.
14. Front Suspension Strut Upper Mounting Nut (1) » Tighten [3x] 22 Nm (16 lb ft)
    
15. Caution: The front suspension strut mount upper cup MUST be fully seated within the strut tower and the front suspension strut bumper stop MUST be tightened to the correct specification. Do NOT over-tighten the stop or damage to the shock absorber will occur.
16. Install the front suspension strut mount upper cup (1).
    
17. Note: The front suspension strut bumper stop MUST be installed with vehicle resting completely on the ground. Do NOT attempt to tighten the stop with the wheels lifted.
18. Install the front suspension strut bumper stop (2) and tighten to 25 Nm (18 lb ft).
19. Measure and adjust the wheel alignment. Wheel Alignment Measurement