Cadillac Owners Forum banner
Cancel

Reverse where are you?

689 Views 3 Replies 2 Participants Last post by  The Tony Show, 
R
Just pulled and replaced my flywheel , one of a few issues now having is reverse. it takes about 7-8 tries to get the car in reverse.
To damn beat up to go back in without a clue what I'm looking for.
Anybody have this issue after installing a new shifter, or clutch or anything down there. What was the remedy?

Thanks,
rgd
Reply
Save
Like
1 - 2 of 4 Posts
The Tony Show
Make sure the bolt on the bottom of the shift lever isn't too tight, as it can bind if it is. It uses a locking nut, so you really don't have to tighten it verym uch at a ll to keep it from working loose.
Reply
Save
Like
The Tony Show
The one that's visible when below the car that attaches the shift lever to the black rod connected to the transmission.
Reply
Save
Like
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cadillac Owners Forum
Cadillac Forums is the perfect place to go to talk about your favorite Caddys including the ATS, CTS, SRX and Escalade.
Full Forum Listing
Explore Our Forums
Informal Lounge, Introductions, General Discussion CTS First Generation Forum - 2003-2007 Seville and Eldorado Forum FWD DeVille 1985-2005, Fleetwood, and 60 Special 2004-2007 CTS-V General Discussion
Top