Hi all,
Looking at replacing my badly worn Driver side lower control arm, had the passenger side replaced last December by a buddy due to worn bushing.
Any idea on the bolt Size so i can make sure I have the right sockets? And anything else special I’ll need beyond a ball joint separator? I was thinking maybe a torch in case the bolts are seized up. I don’t have access to an impact gun but my buddy had used a torch to get the bolt loose on the passenger side when it was replaced.
Havent tackled much suspension work on This vehicle yet. Thanks for any tips!
Also, I was inspecting the passenger side bushing and I’m not sure if it might be wearing already as well, I’ll post pics of both.
Driver Side
![570767]( "570767")
![570771]( "570771")
Pass Side
![570768]( "570768")
![570770]( "570770")
Looking at replacing my badly worn Driver side lower control arm, had the passenger side replaced last December by a buddy due to worn bushing.
Any idea on the bolt Size so i can make sure I have the right sockets? And anything else special I’ll need beyond a ball joint separator? I was thinking maybe a torch in case the bolts are seized up. I don’t have access to an impact gun but my buddy had used a torch to get the bolt loose on the passenger side when it was replaced.
Havent tackled much suspension work on This vehicle yet. Thanks for any tips!
Also, I was inspecting the passenger side bushing and I’m not sure if it might be wearing already as well, I’ll post pics of both.
Driver Side
Pass Side
