Cadillac Owners Forum banner

Power window problem.

911 Views 8 Replies 4 Participants Last post by  Swaman
I have a rear window (driver's side), that hasn't worked since I bought the car. I didn't know it for a while, because I had no reason to open it.

Anyway, based on all the motor issues posted here, I bought a new assembly and installed it today. The thing STILL doesn't work!:mad:

I opened the "module" and heard the relay inside snap (or a loud "CLICK) when I tried the window. Any help on what the problem might be?

If it's clicking but not engaging the motor, is it bad? can just that relay be replace if it is?

Now the window is down 2-3 inches due to the position the new assembly came in, and of course I can't close it.

Thanks for your ideas/advice.:yup:
1 - 2 of 9 Posts
Yes. Whole new assembly.
=======================
check for codes and fuses under the back seat -

the window switches do not control the windows directly -
it goes to the "door module" - and then to the window -

DDM - Driver Door Module -
PDM Passenger Door Module -
LRD - Left Rear Door -
RRD - Right Rear Door -

also inspect the wire harness between the doors for chaffing -
Based on my observation of the "CLICK" when using the door switch, is that an indication that power is getting that far?....and that the relay on the board or module is shot?
I'll check the fuses as you suggest to cover all my bases, but power is getting to the module, so........
I'd hate to be wrong and pay $84 for a used module (or $200+ for a new one) when a $12 relay would do the job.

Thanks again!

ALSO, thanks for the heads-up on the tech. tip location for the '94 suspension trouble light. FOUND IT!
======================

door modules are monitored by the computer -
if they have a problem - a code would be set -

check for codes -
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top