oil level sensor location please cant not find it

xTooltipElement
Service Information
2007 Chevrolet Tahoe - 2WD | Avalanche, Escalade, Suburban, Tahoe, Yukon (VIN C/K) Service Manual | Document ID: 1698846
--------------------------------------------------------------------------------

Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure


Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Place a suitable drain pan under the oil pan drain plug.
Remove the oil pan drain plug (430).
Allow the oil pan to drain completely.
Re-install the oil pan drain plug until snug.
Remove the drain pan from under the vehicle.


Disconnect the engine harness electrical connector (4) from the oil level sensor.


Remove the oil level sensor from the oil pan.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.





Install the oil level sensor to the oil pan.
Tighten
Tighten the sensor to 20 N·m (15 lb ft).


Connect the engine harness electrical connector (4) to the oil level sensor.


Ensure that the oil pan drain plug is tight.
Tighten
Tighten the drain plug to 25 N·m (18 lb ft).

Lower the vehicle.
Fill the engine with NEW engine oil. Refer to Fluid and Lubricant Recommendations and Approximate Fluid Capacities .
Start the engine and inspect for leaks.
© 2011 General Motors Corporation. All rights reserved.

Click to expand...