Hey all,
My ISC motor died yesterday and I was just wondering - can I just adjust the screw on the piston to match the old ISC motor? I went through my haynes manual and found you had to get a tach, apply 12V to one of the terminals to retract it, etc. blah! Way too complicated and I don't want to spend like 70 bucks on a tach!
Is there an easier way to do this?
My ISC motor died yesterday and I was just wondering - can I just adjust the screw on the piston to match the old ISC motor? I went through my haynes manual and found you had to get a tach, apply 12V to one of the terminals to retract it, etc. blah! Way too complicated and I don't want to spend like 70 bucks on a tach!
Is there an easier way to do this?