[2003RC51]

I don't remember the dimensions of the ones that I made but I can figure it out with the GC spacers that I have. I will make some out of aluminum if there is interest. I am not a vendor here so I am not selling anything "yet". I have a really nice set of spacers(MM influenced) that I am making for my car right now and I am sure there will be interest in those. I will become a vendor once I get my toe rods, trailing arms, rear spacers, and motor mounts completed.

 

[2003RC51]

and your kickass for making me a sweet deal on those springs :thumbsup: So i would buy from you again if i needed them :worship:

Btw got any pics with the new GC setup yet??

So it looks like you are as happy as I was when I got those on the car. It is amazing how much it changes the look of the V just from lowering.

No pics yet, That is the spacer setup that I am working on right now. Once I get it done I will take pictures of everything.

We will be ordering the parts to get our lathe up and running tomorrow so I can start turning the spacers soon hopefully.

 

[2003RC51]

there are several people looking to get a set of these they just havent posted here you could probably start a feeler thread to guage interest. or are you already planning to make a few sets?

I will just make a few sets. It will have to wait till we get the parts for the lathe though. So if you need them really soon Nel would probably be the best bet.