Cadillac Owners Forum banner
1 - 3 of 3 Posts

·
Registered
1985 Sedan DeVille
Joined
·
1,883 Posts
Discussion Starter · #1 ·
I am going to replace the hub/bearing assembly on my 1985 DeVille but need to know the size of the nut so I can go get a socket, and I can't find this information in either the FSM or the aftermarket books.... Anybody know?
 

·
Registered
1985 Sedan DeVille
Joined
·
1,883 Posts
Discussion Starter · #3 ·
I bought a 34mm deep-well socket from Sears online and it's a hair too small. It's possible that the aftermarket half-shafts that were put on a while back use a different size.
 

·
Registered
1985 Sedan DeVille
Joined
·
1,883 Posts
Discussion Starter · #5 ·
It's 36mm deep-well. Amazon has J/T brand sockets (same as Sears and others) for less than $20 shipped.

Nice thing is that my Jeep also uses 36mm so I only need to keep one in the tool bag.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top