Heated oxygen sensor help

766 Views 4 Replies 3 Participants Last post by Ranger, May 31, 2007

mikeheid

Discussion Starter · May 29, 2007

Hi Guys,
Getting ready to change the sensor on the exhaust manifold.When lookin at it there seems to be a bar of some sort that runs across.Even with a sensor socket it looks like it would be very hard to get it over it.Or will it still go on?Any ideas on getting this done?
Also it looks like it was welded on somehow or is this just carbon build up on it.

Thanks
mike

Save

1 - 2 of 5 Posts

Ranger

· #4 · May 31, 2007

mikeheid said:
I wonder what this bar is it seems to go directly over top the sensor almost.Any ideas if i will still be able to change this myself?

Thanks

Just like changing a spark plug, and just like the plugs, you need a specail O2 sensor socket.

Save

Ranger

· #5 · May 31, 2007

mikeheid said:
I wonder what this bar is it seems to go directly over top the sensor almost.Any ideas if i will still be able to change this myself?

Thanks

Just like changing a spark plug, and just like the plugs, you need a special O2 sensor socket.

Save

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month