Cadillac Owners Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
Does anyone know how to do this? I installed Xenon lights and my alarm is working again. They shouldn't turn on and off that fast. It's really bad for the bulb and ballast.

Only the low beams blink when the alarm goes off right? I might just switch the high and low beam wires and set the lights on high when I drive at night...
 

·
Registered
Joined
·
6,471 Posts
There's a wire that goes from the theft deterent relay to flash the lights and horn. It connects to a diode pack (taped to body main harness at the rear edge of the left rocker panel). This pack has 3 diodes to control the (1) horn, (2) parking lights, and (3) headlights. The BLK/WHT wire is the input from the relay, the BLK wire is the horn lead, the GRY/BLK is the parking lights, and the YEL wire is the headlight wire. If I'm correct, if you cut the YELLOW wire, you SHOULD stop the headlight flashing and retain the parking lights flashing, and the horn honking. I've never done this but it seems to make sense that it would do what you want.
 
1 - 2 of 2 Posts
Top