Cadillac Owners Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,685 Posts
Discussion Starter #1
Great, a new issue with my V after I just got it back from service last week (it was in for 2 weeks again!). Just started two nights ago, when I push the clutch in it feels and sounds like I'm crushing a tin can. Then when I let the clutch out it makes a popping noise when its about 4 inches from the floor. Anyone else had this problem and can offer some advice to what is causing this? It's been a pain in the ass driving it with this BS issue.
 

·
Registered
Joined
·
1,685 Posts
Discussion Starter #3
Just checked it out, didn't see any spring, but I find a module hanging down from under the dash. Its hanging from some wires and is about the size of a pack of smokes. I wedged it back up under the dash and tested out the clutch again; still making the sound. I'll just take it to the dealer tomorrow morning, its got to get the new radiator installed anyway. I'll let you know what they say about the clutch.
 

·
crushing Vs with my Wurm
Joined
·
12,266 Posts
probably your turn sig/drl module. If it was there will be a spring steel clip on the top of it. Check the faq on drl's for where it goes.

F
 
1 - 4 of 4 Posts
About this Discussion
3 Replies
3 Participants
Florian
Top