Running should be anywhere between 13-16 volts depending on the battery charge.
Changed engine ground wire, no power. 02 DTS
So I had some issues with my dash doing crazy things, things turning off while driving. Discovered that in addition to a new battery, I needed a new engine ground wire. Replaced those both, now I have no power to the dash/ignition. Bolts to the ground wire are both tight and so is the battery. To test I had ground, I used a jumper pack from pos jump point on the front fuse box to the strut bolt, where I've always jumped from. With the broken ground wire, it would not work at all unless I hooked ground to the engine directly. Now it has strong connection and sparks when jumping, but the ignition has no power without the jumper. When the wire was broken, the dash would at least come on and read some voltage. The only thing different between that and this is I have the radiator fans both unhooked so I can make sure everything is good before I put everything back together. Anyone have any idea why the power is not going from the rear battery area to the front?
1 - 4 of 21 Posts
13-16 volts is good enough. At startup, 16 volts is possible.
Ramping down to 14 volts is normal.
If I see vehicle voltage, while running, getting to 13 volts or below, I get nervous. 14's fine.
1 - 4 of 21 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cadillac Owners Forum
Cadillac Forums is the perfect place to go to talk about your favorite Caddys including the ATS, CTS, SRX and Escalade.
Full Forum Listing
Recommended Communities
