My understanding is - now you need to use a TechII or other special equipment to "fully" bleed. The TechII activates the ABS to get the air out of that part of the system. Good Luck and let us know what your results are. Thanks
Brake Hose / Brake Pressure - 2006 STS 3.6L
Hey All!
I just recently replace my rear left brake hose and am now having a problem getting pressure in my brake pedal. Prior to replacing the hose, I lost all of my brake fluid in the reservoir. So, after replacing the hose, I topped off the brake fluid. I though that I bled the brake properly, but I am now not getting any pressure in my brake pedal. When I press down, it hits the ground almost instantly. There is still fluid in the reservoir and my DIC isn't giving me any codes or info on brake fluid/assist like it was. Could anyone please help me figure out how to get pressure back in my brakes? Thanks in advance for any help!
TE
I just recently replace my rear left brake hose and am now having a problem getting pressure in my brake pedal. Prior to replacing the hose, I lost all of my brake fluid in the reservoir. So, after replacing the hose, I topped off the brake fluid. I though that I bled the brake properly, but I am now not getting any pressure in my brake pedal. When I press down, it hits the ground almost instantly. There is still fluid in the reservoir and my DIC isn't giving me any codes or info on brake fluid/assist like it was. Could anyone please help me figure out how to get pressure back in my brakes? Thanks in advance for any help!
TE
1 - 1 of 3 Posts
1 - 1 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cadillac Owners Forum
Cadillac Forums is the perfect place to go to talk about your favorite Caddys including the ATS, CTS, SRX and Escalade.
Full Forum Listing
Recommended Communities
