Cadillac Owners Forum banner
Cancel

2003 O2 Sensor wire melted

2126 Views 1 Reply 2 Participants Last post by  Dan_W, 
A
What’s up every one?
The wires that connect to my O2 sensor from the wiring harness melted on the exhaust. I found out because the check engine light came on and the O2 sensor code came up. I do not want to replace the whole harness, too expensive. There is a connector by the firewall for this part of the harness. Just need to find it, anyone know?
Reply
Save
Like
1 - 1 of 2 Posts
D
I would just splice in and replace the melted section for the least cost if it's on the vehicle side of the harness.
Reply
Save
Like
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cadillac Owners Forum
Cadillac Forums is the perfect place to go to talk about your favorite Caddys including the ATS, CTS, SRX and Escalade.
Full Forum Listing
Explore Our Forums
Informal Lounge, Introductions, General Discussion CTS First Generation Forum - 2003-2007 Seville and Eldorado Forum FWD DeVille 1985-2005, Fleetwood, and 60 Special 2004-2007 CTS-V General Discussion
Top