What is the degree of difficulty for replacement of the 2 upper motor mounts that look like dog bones. they appear to be simply bolted in. is it possible to just unbolt and replace them one at a time or is replacing them a bit more complicated? thanks
Technically, those are torque struts and are the reason that your car and other earlier models (plus later Eldorado) with them do not have the high degree of lower front center motor mount failures - costly and a labor PITA.
Now my radiator is leaking besides my bad head gasket. Are all years the same (2000-2005)? Does it have a oil cooler as I can't see sh**t in there. Are all radiators for 2000-2005 models of the 4.6 interchangeable. I have been looking online to buy one but I am not sure what to buy. I have to...
I lost my Mother a few months ago and have acquired her 2005 Deville...it has been sitting for a couple years or so come to find out so it has some issues otherwise it seems to be a solid car...I am hoping for some guidance to find a direction for remedying the situation...
this caddy had the compressor come apart and clog up the orifice tube .the low freon came on the display. replaced oriface tube , reciever - dryer, compressor, all "o" rings in system. all hoses - lines, evaporator and condenser were cleaned and flow tested. pump it down the oil and freon. i...
Please help me my car doesnt need a new bearing because it doesnt chirp or squeal or grind.. so I dont think. Could a whirring noise during accelerate that gets higher when faster and then it gets slower and lower pitched when slowed, be a bent rim? I dont know what to fix an I dont qant to...
I had 2 bad (leaky) injectors in my 91, so I replaced all 8 of them with the good injectors from my 92. However, one by one, they seem to be cracking at the seam of the injector and slowly leaking out. I replaced 2 the first time, then 1, and now another one is cracked. I don't think I was rough...
RON93 · updated 
DSPICIBL1 · updated 
meted · updated 
Lucas d · updated 
Mr. '92 · updated 
