^Some derbies, yes. That IS a rule. The only vehicles that are officially recognized as "banned" from derbies (though still allowed in plenty, especially the smaller ones) are the Eleventh Gen ('80-92) Brougham and the matching (80-84) DeVille, alongside the early 60's Imperials.
Apparently the front ends are good,but not the rear.This one is going to Illinois.
I am looking for a tail pipe for my '79 Sedan DeVille. The one on there is completely rusted through and in two pieces. Thank you.
Just buy new. Any parts store can get it for you, or order online from rockauto.com
Last call for parts from my 1994 Fleetwood Brougham parts car. It's going to scrap next Saturday.
PM me if you have a request. If I can remove it easily, it will be cheap. No motor/trans/carpet/wheels/front seats/dash top/radio/windshield. Have a grey rear seat. Extra window motors/regulators. Full set of black door panels. Car is factory sunroof. Only stainless trim left is LR panel and wheel skirts (more than two). I have doubles/triples of some things like dash clusters/trim. Back bumper is bad, front is nice.
Unfortunately, those bolts were the first to go when I pulled the motor last year. Nothing special, four regular ones from the bottom, two torx head screws on the side.
I'm looking for some factory rims tonfit my 79 caddillac coupe deville I already have the factory hubs...
Where are you? I still have the factory steel wheels from my 81 Fleetwood. I saved them after I swapped to wire wheels.
Parting out a 307 out of an 84 Delta 88. This should be the higher output 307. Wider runners in the heads and intake. Ran great but developed a rattle like a broken rocker. We took it apart and didnt see anything. 200R4 that was attached is for sale and in good condition also.
Hi all you Cadillac Folks,
I got a 1981 Cadillac Deville, needing a Height Sensor assemblyAttachment 112481.
also im looking for th A.I.R. Pipe ans the A.I.R. Manifold pipe.
Was just at the PICK-A-PART yesterday and the 81 I was looking at had the Height sensor on it and it looked complete. I had never seen one so wasn't sure just what it was until I seen your post and then looked in my manual and sure enough that was it. Not sure where you are or if you want me to grab it next time I'm at the wreckers. I'm sure the A.I.R is there also as the only thing I noticed that was missing was the rad. Not sure on their pricing but I could call and find out. Everything would have to be pulled.