New Member Hello Everyone

[Ñî†ëßrèéÐ]

Hello Members,

First off Im a new Member and Im glad I found this site. Great place to talk with other people who have the CADLOVE. I will be in here daily getting tips on my New Project and I hope I can help with anything that I know.

O.K. I have seen this question asked a few 1000 times, But I havent seen anything on the HOWTO part of it - if it was listed Sorry cause I have gone through alot of posts and still havent seen this answered.

REAR FILLER PANELS

When you go to install do you have to remove the BumperEnds or the Bumper ? Or can you go around them ?

( Yeh I know You want to kill me But I did look and I didnt find it so I had to ask.)

My New Project :

1984 Fleetwood Coupe
Black / Burg Velour
C.C. Grille
400 C.I. ( Olds I think But a 500 is in the works)
Body Stock - But looking to add Euro Kit - Saw Moldings on Ebay for under $150.00 Think Im going to jump on them)

[X_WizarD_X]

First off to the forum's.....

They can be replaced without removing the bumper, but you have to remove the bumper ends (including the taillights). There are a couple bolts that hold on the bumper ends that can be a bitch to get to, but with patience it is a fairly easy job....You may also have to remove the chrome rocker panel strip along the bottom of the rear quarter panel if your cad has it....

[Fleetwood Blaq]

Yeah, it's a really easy procedure. I had to replace the ones on my 85 Fleet. The hardest one would be the first one because you are just figuring out what to do. There are a couple of bolts inside the tailights plus some small nuts on the bracket that helps fasten the fillers to the car. Should take an hour at the most for inexperienced folks. Good luck and welcome!!

[Pianoman72]

Welcome congrats on your new ride. What is the euro kit if I may ask? I looked around on ebay for one.

[FASSTWOOD]

Welcome nitebreed. I did my rear fillers on my car but I took the whole bumper off. I guess I did it wrong, but it was easy enough to do though.
well anyway, Welcome!!!