I am rebuilding a 62 390 and want to dyno it when I am done to break in the engine to tune the carb and dial in the dist timing curve. My question is, since the stock ring gear is on the convertor can a flywheel for a 472/500 be bolted on (will it fit) and without balance problems?
Thanks for any input on this.
Thanks, but engine dynos are not set up to accomidate or be driven of a transmission. They have abell housing type rear mount and are driven off the crankshaft via a manual trans type flywheel. Problem I have is the 62 390 wasn't available with a manual trans that I can tell, so I am looking to adapt something else for test purposes.