Cadillac Owners Forum banner

Where can you get headers for a Northstar?

11K views 10 replies 9 participants last post by  94CaddyConcours 
#1 ·
I've got a Northstar in a sand rail (aka dune buggy) and I need a set of headers for it.

It's really wide open and could accommodate a number of designs but I can't find anything on the web etc.

Any ideas?
 
#5 ·
You could always hack off the piping from the stock manifolds and use the base of each manifold as a mounting point for new piping. Most decent exhaust or performance shops should be able to weld up a set of headers for you. Probably cheaper than buying a set (especially since they're hard to find for these engines). You'd probably want to machine out the holes in the base a bit, and chamfer the edges a little more before you have someone weld pipes on there, the shop should be able to do that as well though. Good Luck, sounds like a bad ass project.:thumbsup:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top