Northstar Engines and System Technical Discussion Discussion, Resetting Change Oil Message in Cadillac Engine Discussion; Hi, I am a new 96 STS owner. My books have not arrived from Amazon yet. I am about to ...
- 09-18-03 10:33 PM #1Cadillac Owners Fanatic
- Automobile(s): 1996 Seville STS
- Join Date
- Sep 2003
- Fort Mill, SC, USA
Resetting Change Oil Message
I am a new 96 STS owner. My books have not arrived from Amazon yet. I am about to change the oil and have a message on the dash to Change Oil.
How do I reset that message so it goes off and comes back on at the recommended interval?
Also, I am changing the blower motor and the Plastic Cover that the blower motor screws through and which covers the A/C unit has decayed and is flaking away. I am considering changing it. They cost $110 from the dealer. Is it possible to replace this piece without removing the engine?
- 09-19-03 12:02 PM #2Cadillac Owners Member
- Join Date
- Jun 2003
Re: Resetting Change Oil Message
To reset the oil change indicator, make sure the oil message is displayed...then just hold down the reset info button for 10 seconds and it will go away, as the same for the oil life percentage.
- 09-20-03 12:54 AM #3
Re: Resetting Change Oil MessageOriginally Posted by FirstTimeCaddy
That worked. I was holding down the big Info button in the middle then pressing the info reset button. All that was necessary was the info reset button.
Also, Eight Quarts of Mobil 1 10W30 and a Mobil 1 Filter. Like someone said - "It has a big stomach".
- 09-28-03 04:22 PM #4
Re: Resetting Change Oil MessageOriginally Posted by jonrodman
Apparently it can be done easily if the front two engine cradle bolts are removed and the engine and transmission are allowed to drop a few inches. This opens up a space between the engine and firewall apparently creating sufficient clearance to remove the Blower motor and the plastic cover.
I am going to give it a try within a couple weeks.
+ Reply to Thread
Gear in this thread - Powered by O'Reilly Auto Parts
- PowerTorque Tools - Universal Joint Set
Universal Joint Set - 3 Piece; 1/4 Inch, 3/8 Inch, 1/2 Inch
- PowerTorque Tools - 1/2" Dr Torque Wrench
1/2" Dr Torque Wrench - 1/2" Dr Torqute Wrench (18" handle, 10-150 Ft/Lbs)
- PowerTorque Tools - Stubby Hex Bits Socket Set
Stubby Hex Bits Socket Set - 9 Piece; 1/4" & 3/8" Drive; SAE Stubby Hex Bit Socket Set; Contains: 1/4" Drive: 1/4", 5/16" & 3/8", 3/8" Drive: 7/16", 1/2", 9/16", 5/8", 11/16" & 3/4"