Northstar Engines and System Technical Discussion Discussion, 02/03 Alternator regulator in Cadillac Engine Discussion; I have an 02 or 03 (cant remember which year) Northstar in a 1986 Fiero running a standalone ECU. It ...
- 07-09-07 01:47 PM #1Cadillac Owners Member
- Automobile(s): Cadillac
- Join Date
- Jan 2007
02/03 Alternator regulator
I have an 02 or 03 (cant remember which year) Northstar in a 1986 Fiero running a standalone ECU. It has the nippon denso alternator, and I think the output was PCM controlled. I have the red wire hooked up to power, it charges, but I think it is overcharging. I have a wiring diagram for both year alternators, but the other 2 wires go to the PCM, 02 go to some monitor pins on the PCM, but in 03, one wire goes to an input, and one to an output. And I think this is an 03 motor. Is it safe to leave these 2 wires disconnected? Or are they for a PCM controlled regulator?
+ Reply to Thread
Gear in this thread - Powered by O'Reilly Auto Parts
- PowerTorque Tools - Universal Joint Set
Universal Joint Set - 3 Piece; 1/4 Inch, 3/8 Inch, 1/2 Inch
- PowerTorque Tools - SAE & Metric Socket Set
SAE & Metric Socket Set - 19 Piece; 3/8" Drive; Ratchet Handle Set
- PowerTorque Tools - Metric Hex Bits Set
Metric Hex Bits Set - 7 Piece; 3/8" Drive; Metric; Metric Hex Bits; Contains: 3mm, 4mm, 5mm, 6mm, 7mm, 8mm & 10mm