Cadillac Owners Forum banner
M

Reaction score
37

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews Media Albums About

  • · Registered
    2000 Seville STS
    Joined
    ·
    0 Posts
    Mark: I have a 2000 Seville STS with the Service Stability System and ABS and Tractions Control lights on. You mention getting just the EBTCN side on eBay for $50+. I don't seem to be able to find any on eBay. Do you have any suggestions. Thanks and have a good day.
    Norm

    · Registered
    Deville DTS 2003
    Joined
    ·
    110 Posts
    Mark, I have read what you have posted about EBCM replacement and other threads that I have found. I have an '03 Deville DTS with the codes C1214 AND C1248 and the ABS, Brake and Traction Control warning lights on. O.K. So I took off the wheel and splash guard and removed the 6 torx screws to remove the EBCM to get it repaired. For the life of me I cannot get the unit to separate from the pump housing. I have read that you just separate one corner and it should pop off. How do you get the one corner to come loose. I can't get anything in there to pry it. Tried screw drivers, pulling, etc., etc. Nearest Caddi dealer is over 110 miles away and locals (small town) have never done it before. Any clues you can give me? Any help is much appreciated!

    · Registered
    94 Seville SLS
    Joined
    ·
    8 Posts
    Hey Mark, got a question for you. In a recent thread you mentioned that if you swap PCMs, they have to have the same servo part #. What happens if they aren't the same? I put a 95 Deville PCM in my 94 SLS without comparing #s and everything is great, (it solved a lot of problems) except have a code (P041) that won't go away even after changing the cam sensor and ICM. Could this be the PCM?? Test equip says the cam signal doesn't meet the required 2 volt minimum. Any help would be appreciated. Thanks!
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top