Cadillac STS Forum - 2005 through 2012 Discussion, memory for driver,s seat in Past Cadillac Vehicle Discussion; Apology for a new message though I could not see my first thread. How does one leave the seat in ...
- 02-18-06 09:54 PM #1Cadillac Owners Member
- Join Date
- Sep 2005
memory for driver,s seat
Apology for a new message though I could not see my first thread. How does one leave the seat in the setting from the last drive on the STS? Each time I drove it , I had to reset the seat all over again I am sure there must be a way ,what is it? I dont have access to the manual.
- 02-18-06 11:55 PM #2Cadillac Owners Fanatic
- Automobile(s): '06 STS V8 RWD - Black Raven/Cashmere - no ACC
- Join Date
- Jul 2005
Re: memory for driver,s seat
Yea you have to save your seat position in the drivers memory...
First of all check the BACK of the remote key (transmitter) that you have... what is the written number on the back ?... If it is 1, then you are driver 1... If 2, you are driver 2
Now, do your favourite seat position then press the "Config" button under your "Route" button
you will get a screen with buttons, Go to "Vehicle"... Then "Memory"... Now you can choose between driver 1 or 2 depending on the transmitter (remote key) you are using..
go to "store drivers settings".... here you can set your driving seat position
Whenever you get into the car, memory will call itself automatically depending on the transmitter it recognizes...
+ Reply to Thread
Gear in this thread - Powered by O'Reilly Auto Parts
- PowerTorque Tools - Crowfoot Wrenches
Crowfoot Wrenches - 9 Pcs 3/8" Dr Crowfoot Wrench Set - Metric
- PowerTorque Tools - Stubby Hex Bits Socket Set
Stubby Hex Bits Socket Set - 9 Piece; 1/4" & 3/8" Drive; Metric Stubby Hex Bit Socket Set; Contains: 1/4" Drive: 6mm, 7mm, 8mm & 10mm, 3/8" Drive: 12mm, 14mm, 17mm, 18mm & 19mm
- PowerTorque Tools - Universal Joint Set
Universal Joint Set - 3 Piece; 1/4 Inch, 3/8 Inch, 1/2 Inch