: Installed Lingenfelter CAI tonight..



HDMLNIUM
06-18-05, 12:27 AM
Well I didn't feel like working under the car tonight so sense the Lingenfelter CAI kit showed up today it was a no brainer.
My thoughts so far is that this is a very nice quality CAI kit , it went together very easy and came out great. I added some "quite a bit, lol" foil tape to seal the box better from the engine heat. But all in all I think it will work out great..:thumbsup:
Bill

A couple pics..
http://img.photobucket.com/albums/v466/HDMLNIUM/Lingenfelter-CAI.jpg
http://img.photobucket.com/albums/v466/HDMLNIUM/Lingenfelter-CAI2.jpg
http://photobucket.com/albums/v466/HDMLNIUM/th_front-1.jpghttp://photobucket.com/albums/v466/HDMLNIUM/th_engine-yeah.jpghttp://photobucket.com/albums/v466/HDMLNIUM/th_rear-1.jpg
05 CTS-V--- Light Platinum
3M Clear Bra and Tinted windows, LS6 Emblem, Stealth-V z06 fuel rail covers, Lasstss Billet interior pieces
B&B Headers-high flow cats-and 3" resonator exhaust, Lingenfelter CAI, UUC shifter, BMR kit
Online Photos http://photobucket.com/albums/v466/HDMLNIUM/

JAMESDEVANS
06-18-05, 12:31 AM
Snorkel In Or Snorkel Out?

HDMLNIUM
06-18-05, 12:40 AM
Snorkel In Or Snorkel Out?

Snorkel is out, it was a lot easier than everyone has said. I used a light through the grill and a long screwdriver through the opening in the back. Just stuck the screwdriver behind the ruber of the snorkel and pried it over the clips. Come out in about 5 minutes and didn't hurt it a bit...:hmm:

Bill

wildwhl
06-18-05, 12:47 AM
How does she run/sound?

HDMLNIUM
06-18-05, 01:02 AM
:histeric: She looks like this in the back....

http://img.photobucket.com/albums/v466/HDMLNIUM/Brembo-Brakes.jpg

Started putting on the BMR parts the other night, only got as far as getting the pinion support on. The exhaust is off from after the headers on right now. So I didn't start it, I bet she would bark though if I did...:shhh:
I was hoping if I took my time doing all the BMR stuff that the X-pipe would show up. Then while it was all apart I could just put that in instead of the resonator center section when I put the exhaust back on. I ordered the X-pipe the same night as the CAI so I hope it shows soon. I have a dyno appointment this coming Tuesday a 4pm, so if the x-pipe doesn't show by Monday afternoon I will just put the exhaust back on the way it was with the resonator center section. I would love to go for a drive right about now though..
Just need to do the BMR trailing arms, toe rods, Wheel hop kit, put the exhaust back on, put the rear wheels back on, jack her back up and get her off the stands, then give her a nice bath, and then she will be ready for a road test..
Holly run on sentence.....:bonkers:

Bill

Parker
06-18-05, 12:04 PM
Good luck with the installs!