: VMR wheels? will they fit?



BigMilk
05-29-13, 08:42 PM
These wheels are huge with BMW and Audi guys. They look great and don't cost a ton. What offset would I need for a 2010 sedan to make these work?

Does anyone on the forum have them?

http://www.velocitymotoring.com/wheels.html

Low_ET
05-30-13, 08:20 PM
There is a lot more wheel discussion in the Appearance Forum.

As far as the wheels go, the page you sent has a few hundred combinations of diameter - width - offset and you didn't say whether you want staggered (wider in back) or a square set-up.

For example: If you want a square set-up with 9.5" width (what I use on my sedan)
In the front, you need a 45 mm or less offset.
It the rear, a 60 mm offset works with the same width.

If you have something particular in mind, I made a spreadsheet with the clearances so I can answer "what if.." questions regarding wheels.

DCV
05-30-13, 08:42 PM
VMR wheels are very heavy and they will flake off their ckearcoating or paint. Save your money for a better wheel. See the Audi forums.