: Wire boot stuck in cylinder 2



Skiller.
03-11-10, 08:06 PM
Hi,

Today, I was trying to wipe up the oil in cylinders 2 and 4 (I do it once every few months) and when I tried to remove the boot in 2, it wouldn't come out. I didn't want to get too forceful, since the wires are brand new, but it just would not come out.

Is the fact that I didn't grease the boots coming back to bite me in the ass? :thepan:

Is there anything I can do to get it out without ruining the wire?

jsiddall
03-11-10, 08:50 PM
Did you try to rotate it before pulling? Usually doing that until the seal breaks will allow it to come out easily.

Skiller.
03-11-10, 08:56 PM
Did not try that. Will give it a try, thanks!

Skiller.
03-12-10, 07:37 PM
Got it out!