: K&N filter install



Mikevette
12-11-09, 04:58 PM
Hey guys, have a question for those of you who have installed a replacement air filter. I removed the black plastic top of the grill area with the GM Performance placard and found a elctrical connector attached to the bottom side of this black plastic piece and no wires harness anywhere that it could have been connected to. It was attached to the around where the hood latch is located. Did you find this same connector on your V's also? I'm trying to figure why it was stowed there and what it's used for? It looks like an OB2 connector of some type. Any caddie mech's want to take stab at this one

Mike P.:bigroll:

cbloveday
12-11-09, 09:25 PM
I have the K&N and did the swap myself but never removed that plastic top to get to the filter. subscribed