: Crankshaft Position Sensor Question



whoareyou4
09-19-09, 04:32 PM
I have a 2001 and today I am trying to replace the Crankshaft position sensor.
My wire to the sensor is wedged behind the oil cooler lines. One post on here gave instructions on replacing the sensor, and it says to loosen the nuts that hold the cooler lines in place. Has anyone does this without removing the oil filter housing. Like I said my wire is buried right smack behind them

WGoins88
09-19-09, 04:52 PM
I simply cut the wire off of my old one on both ends and pulled the old wire through, then ran the new one in a area where it wouldn't come in contact with the exhaust, using zip ties. I wish I could get pictures, but my friend has my camera and my phone's camera sucks.