Specter Werkes Sports
09-18-09, 11:57 AM
We have finished the spoiler and have them in a box ready to ship today. Here are some pics on a V.
$395 plus shipping.
http://i150.photobucket.com/albums/s88/specterwerkes/DSCN1575.jpg
http://i150.photobucket.com/albums/s88/specterwerkes/DSCN1569.jpg
http://i150.photobucket.com/albums/s88/specterwerkes/DSCN1567.jpg
http://i150.photobucket.com/albums/s88/specterwerkes/DSCN1568.jpg
http://i150.photobucket.com/albums/s88/specterwerkes/DSCN1573.jpg
Specter Werkes Sports
09-18-09, 12:46 PM
Tooling is finishing up today, Should have the first part next week.
248-583-9559 to order
1-2-N-V
09-18-09, 01:45 PM
Nah not my cup of tea:duck:
anonfrank
09-18-09, 02:27 PM
That looks good! It complements the edgy Art and Science theme of the V very well, without being overwhelming (e.g. "rice"). Can we have a side view, please? And is it actually functional (e.g. does it add more than the 50 lbs of downforce at high speed that the stock third brake light/wing has), or is this purely for style?
Silver -V-
09-18-09, 02:48 PM
Looks sharp, but does it allow water to drain off the trunk lid?
Specter Werkes Sports
09-18-09, 04:01 PM
Side view
http://i150.photobucket.com/albums/s88/specterwerkes/DSCN1572.jpg
Without getting it into a wind tunnel we will not have any hard data as to the actual amount of downforce produced.
LUVMY04V
09-18-09, 05:34 PM
With that spoiler the diffuser thingy and the lights need to be tinted or darkened badly IMO
Spoiler looks cool though!
Specter Werkes Sports
09-21-09, 04:18 PM
Instructioons for Cadillac CTSV-R Spoiler
1 – CTSV-R Spoiler
2 – 1/4X20 bolts
1. Check for any defects from shipping
2. Pre-fit spoiler to vehicle. Spoiler should sit in its natural position when placed
on the rear deck against the CHIMSL
3. Tape the 2 supplied transfer templates to the bottom of the spoiler aligning
holes.
4. Place spoiler on the deck and tape down the transfer templates.
5. Remove the spoiler and center punch the holes from the template.
6. Drill holes slightly larger than the supplied hardware.
7. Spoiler must be primed with epoxy-catalyzed primer. Apply 3-4 heavy coats
8. After splitter is primed, guide coat and block sand.
9. Apply desired color to spoiler
10. Install on vehicle using 3M tape down the center of the spoiler.
11. Finger tighten the two bolts first before fully tightening
12. Tighten down the bolts being careful not to overtighten..