: crank sensors



stoveguyy
09-19-07, 10:31 AM
96 STS. are the connectors on the wire harness for the crank sensors the same? can you reverse them and have no issues? i pulled my motor and when i plugged the sensors in, 1 felt ok but the 2nd seemed tight. the car runs fine and no codes. just wondering.

Ranger
09-19-07, 11:10 AM
Seeing as there are two of them and they are designated sensor "A" & "B", I would suspect they should not be switched. As to whether or not they can, I don't know, but I would guess that they would have different connectors to prevent that.A FSM or a close inspection would tell.

AJxtcman
09-19-07, 11:40 AM
96 STS. are the connectors on the wire harness for the crank sensors the same? can you reverse them and have no issues? i pulled my motor and when i plugged the sensors in, 1 felt ok but the 2nd seemed tight. the car runs fine and no codes. just wondering.

The upper connector will only go on the upper one. The lower will go on both.