Those of you looking for a lower insert. Here one is..

[Blackillac9]

http://cgi.ebay.com/ebaymotors/03-07...spagenameZWDVW


not a bad buy for $84.00

[samoskacts03]

yah its alright i just dont like the piece that splits it right down the middle like some buck teeth....good deal though i think rblimas has the same one

[AmericanMuscle]

Anyone know how that Grille - 4 you insert fits? Good quality or crap?

[Rey Rey 650]

Has anyone had difficulties inserting their lower grilles? My License plate frame is in the way.... I still havent put on the lower grille that LUVMYCADDY made....

[samoskacts03]

all lower mesh grills are aftermarket so im sure youll run into a little gap here and there, but i havent seen anything to horrendous with lower grills

[samoskacts03]

Originally Posted by Rey Rey 650

Has anyone had difficulties inserting their lower grilles? My License plate frame is in the way.... I still havent put on the lower grille that LUVMYCADDY made....

yah the frame hangs over the grille a little but its nothing thats gonna stop ya, have a partner just pull it upwards while your putting it in place

[Rey Rey 650]

Originally Posted by samoskacts03

yah the frame hangs over the grille a little but its nothing thats gonna stop ya, have a partner just pull it upwards while your putting it in place

Can the bumper rip or tear..... I was pulling it back but was a little skeptic off something ripping off

[samoskacts03]

Originally Posted by Rey Rey 650

Can the bumper rip or tear..... I was pulling it back but was a little skeptic off something ripping off

well i mean if you he man it and rip the damn thing up like an animal im sure it wont end up in good results haha but just have someone slightly pull it up while you position it in the space...shouldnt be more than a min or two if you get in a bind to position it, then you just work from there since you should be underneath the license plate frame by now...then just slid underneath or put it on same stands and secure it in the back, i remember luv saying his was attached with wire?? shouldnt be to bad

it looks good rey rey filling in such an ugly empty space haha...no go outside in the bay area weather, stop thinking about barry bonds, and do the mod!!!!! haha

[Caddy Man]

I have the T Rex mesh insert that they had a group buy for recently. It looks just like the one posted. The fit is excellent. I had to remove my front plate holder though to install it. I chose to just leave it off, as Michigan does not require front plates anyways.