Hi,
I'm new here and I apologise for trotting up the same question relating to headlights.
According to the great bible of UPS estimates, my black projector lamps, purchased from ebay, should arrive tomorrow. I had hoped they would arrive before tomorrow since the car is being fitted with a remote starter and I had hoped to poach the electricians wisdom on wiring.
Anyway, I have seen these lights before and am aware that a wiring modification needs to be done. I am, and trust me on this, a complete electrical moron. For example, taking a wire from the hi beam side was fine, but to my mind, I wasn't then sure which of the wires on the low beam side it was to go to
I would be extremely grateful if anyone who has already done this, could provide idiot proof directions on this link for me to print off and work with.
Semi-related, and perhaps a little naive is a bulb question.
I have a set of driving lights on the car, fitted because the headlights are so poor. These are aligned correctly and are fitted with 100w bulbs, which are much clearer but because they are aligned do not bother other motorists. Given that from what I have read, the projectors low beam (H1) are pretty poor, my question is this;
Can I, ignoring the legality for a minute, put 100w's in my low beam, is their a downside, heat, wiring, fuse, relay etc, or anything else I should be aware of???
I apologise if the questions are a little simplistic and hope everyone in the US is having a great Thanksgiving.
Mick