I've been noticing that there is basically no walkthroughs on this site, and they're normally pretty helpful on other forums, so i'm going to start putting them up for anything I do. This first video is how to install the LED bulbs into the dome lights. Everyone talks about how hard it is, and it's actually VERY easy, took about all of 10-15 minutes from start to finish. I'll put tips for all the other bulbs here as well, and add videos when i get the time to edit/upload. For now, here is the video for the dome light install:
The bulbs are from v-leds, they're size 194; 5-led bulbs. You need 13 of them. They're sold in pairs. They're not too expensive at all, about $35 for the whole car. I bought 2 sets so I would have plenty if any of them go out. I've bought v-led's before and never had any problems out of them.
Dome Light Install:
The rear dome light install is MUCH harder, but it's just because there is not near enough wire length to get your hands in to unclip/reclip them. The rears are the exact same as the front. The clips are tough to reach though, I did it with a flat-head screwdriver, I'll have a video up of this one shortly.
The under-dash bulbs are easy, just pull out and push in the new ones.
The under door lights are easy, just put a flat head screwdriver on one end and pry the lens off, then pull out the blub and replace.
The license plate bulbs are easy, just pry the lens out on the outside, then the inside will come out, the whole unit will come out, and twist the bulb to remove.
This is an AWESOME looking mod that adds a touch of class to your vehicle for a minimal amount of money. More pics of the lights finished to come.