[MrAceman]

Sorry... no pics from behind. Not sure I could get enough room for my camera to focus.

However I'll have to take it all apart again soon anyways since my Carbotech pads just came in. I'll have to pull the calipers to change the pads and rotors off to wire brush them.

I'll try to get some more pics at that point.

The picture below is from when I did the passenger side. It's not from behind but the rotor and caliper are back on so maybe this will help a little.

BTW, the driver's and passenger side are a little different as far as where you can run the hosing. The driver's side was much easier imo. On the passenger side I actually ended up dremling a little bit of plastic off what I believe is the housing for the headlight washer (I could be dead wrong on that).