Items needed:
1 Flathead Screw Driver; 2 Trunk Lift Supports
Time: 5 (-) min
Removing old lift support
Use screwdriver to remove the retaining clip from the strut by lifting the clip up
Remove the top part of the strut
Do the same for the bottom (or you can just pull it off)
Installing the new Trunk Lift Support
Lift up the retaining clip (DO NOT remove) so that the ends are not in the mounting hole
Mount top Strut to the Ball Joint (Clip should automatically slide into place)
**If your bottom mount is facing the wrong way, just stick the screwdriver in the hole a\and rotate it until it is aligned**
Repeat same steps for the bottom.
Voila No more trunk lids hitting you in the head
This is a easy DIY. I attached a pdf with pics.
