Ok,
Here are photos of the finished product.. Few more things added... The cover fits just fine, but I had to stack two washers under the two rear cover hold down bolts, and two washers under the single left front cover hold down bolt (to raise them up higher). The front cover bolt comes off with a 10mm wrench.
On the left side (the two bolts underneith where the three map sensor brackets fit onto).. I had to take those mounting bolts out, and place 5 washers underneith them and then screw them back on (use a 1/2" open end wrench).. The sensors will sit up higher, but still plenty of clearance. The right side, and rear bolts don't need this done. The reason for this is to give clearance to the front left water tube at the supercharger. From this point you'll have to tweak it yourself as every pipe will be slightly differant. (see photo)
If you go back an look at my original photos.. You'll notice that i also had to cut the stage-2 pipe's mounting tabs down in the front (i also rounded the cut),,, If i would happen to take this apart again, i would cut the mounting hole into a slotted hole by removing some of the front, cutting into the hole for more movement (which i will most likely do).
The whine from the supercharger is only noticable under moderate to hard throttle.. At Regular or Highway Cruise speeds it is totally quiet!!
*This takes some work to do.... This is only for referance purpose to show that it can be done.. Only attempt this if you know what you are doing.. If you mess up your stage-2 pipe, or something doesn't fit right, i take no responsability what so ever.